Verify that the SVMs are running and the aggregates are online
Suggest changes
PDFs
After the switchover is complete, you should verify that the DR partners have taken ownership of the disks and the partner SVMs have come online.
When you run the storage aggregate plex show command after a MetroCluster switchover, the status of plex0 of the switched over root aggregate is indeterminate and is displayed as failed. During this time, the switched over root is not updated. The actual status of this plex can only be determined after the MetroCluster healing phase.
-
Check that the aggregates were switched over by using the storage aggregate show command.
In this example, the aggregates were switched over. The root aggregate (aggr0_b2) is in a degraded state. The data aggregate (b2_aggr2) is in a mirrored, normal state:
cluster_A::*> storage aggregate show . . . mcc1-b Switched Over Aggregates: Aggregate Size Available Used% State #Vols Nodes RAID Status --------- -------- --------- ----- ------- ------ ---------------- ------------ aggr0_b2 227.1GB 45.1GB 80% online 0 node_A_1 raid_dp, mirror degraded b2_aggr1 227.1GB 200.3GB 20% online 0 node_A_1 raid_dp, mirrored normal -
Confirm that the secondary SVMs have come online by using the vserver show command.
In this example, the previously dormant sync-destination SVMs on the secondary site have been activated and have an Admin State of running:
cluster_A::*> vserver show Admin Operational Root Name Name Vserver Type Subtype State State Volume Aggregate Service Mapping ----------- ----- ---------- ---------- ----------- --------- ---------- ------- ------- ... cluster_B-vs1b-mc data sync-destination running running vs1b_vol aggr_b1 file file